Basic Operation

This chapter covers battery installation, base mounting, charging, button operations, indicator light meanings, data transfer, and everyday usage specifications for the Lixel K2.

Battery Installation

Press the battery buckle.
Insert the battery into the bottom of the device and make sure it is fully seated.
Release the buckle and confirm that the battery is locked.

Note

Failure to lock the battery may cause the device to slip.

Base Mounting

There is a threaded hole at the bottom of the battery handle. Clip the device into the base, lock the bottom bolt, and place the device on a flat surface.

Use the provided charging cable to connect the charging adapter to the battery to start charging. A full charge takes about 2 hours. During charging, the indicator light shows the current battery level.

Indicator Light	Battery Level
	0–24%
	25%–49%
	50%–74%
	75%–99%

Function Key Operation

Function	Button Operation	Device Status
Power On	Press and hold for 4 seconds	The indicator light changes from slow-flashing blue to solid green, and the device enters standby mode.
Power Off	Press and hold for 4 seconds	In standby mode, press and hold for 4 seconds. The solid green light changes to flashing white while the system saves data; the device powers off once the light turns off.
Start Scanning	Double-click	In standby mode, double-click the button. The light changes from solid green to fast-flashing green, then slow-flashing green; the LiDAR starts rotating and the device enters scanning mode.
Stop Scanning	Double-click	In scanning mode, double-click the button. The light changes from slow-flashing green to fast-flashing green, then solid green; the LiDAR stops rotating and the device returns to standby mode.
Control Point Collection	Single-click	In scanning mode, single-click the button. The light stays on for about 1 second, then returns to slow-flashing green, indicating the control point was recorded successfully.
Switch to USB Mode	Single-click → single-click again while white light is on	In standby or USB mode, single-click; the white light stays on for up to 3 seconds. Single-click again during this time to switch. If no action is taken within 3 seconds, the device keeps its current mode.

Indicator Light Description

Light Status	Meaning
No light	Device not started
Slow-flashing green	Scanning mode
Solid green	Standby mode
Solid blue	USB mode
Solid yellow	Device not activated
Solid red	System error
Slow-flashing blue (~30s)	Powering on
Solid white	Switching between standby and USB mode
Fast-flashing green	Scan starting / stopping
Alternating red and green	Firmware upgrading

Data Transfer

In standby mode, connect the device to a computer with the provided USB 3.1 cable.
Switch to USB mode via LixelGO or the button shortcut.
Once the computer recognizes the device, you can copy data.

Note

USB mode automatically disables after a restart.
After enabling USB mode, if you want to continue scanning you must manually exit USB mode or restart the device.
Using a non-standard USB cable may slow down transfer speeds.

Basic Usage Specifications

The Lixel K2 is a high-precision surveying device. Follow the specifications below when operating it.

Handle gently and avoid impacts

Dropping or hitting the device may reduce measurement accuracy, cause malfunctions, or even complete damage.

Check that connections are secure

Before use, confirm that the base and battery are tightened and locked to prevent the device from falling accidentally.

Protect against water and dust

Protection rating IP54 (splash- and dust-resistant).
Do not use in heavy rain, standing water, or dusty environments.
Clean with a soft dry cloth or the provided cleaning cloth. Keep the LiDAR and lens areas clean and do not touch them directly with your hands.

Avoid overheating

Do not block the ventilation openings during use.
Avoid touching the heat-dissipation areas with your body.
The device automatically shuts down to protect itself when it overheats; wait for it to cool down before using it again.